NaCl改性沸石去除水中低浓度铅的研究

实验研究了NaCl改性沸石去除水中铅的效果,比较了沸石改性前后对铅的静态平衡吸附量变化,着重考察了吸附时间、pH值、竞争离子以及有机物对去除铅效果的影响。结果表明:NaCl改性沸石吸附铅速度快,对铅有很好的去除效果,平衡吸附量由改性前的28.57mg/g提高到了32.26mg/g。pH值对NaCl改性沸石去除水中铅的效果有较大影响,在pH=6～7时,去除效果最佳。水中竞争阳离子和有机物的存在,在一定程度上会降低铅的去除效果;随干扰物质浓度的升高,NaCl改性沸石对铅去除率出现了明显的下降,但当干扰物质和水样中铅浓度相当时,NaCl改性沸石可对铅保持很高的去除率。     

气相色谱仪检测溶解气H_2、He最佳观测条件的选择

通过色谱柱、固定相以及载气流速的选择性实验 ,提高了气相色谱仪在观测地下水中H2 、He分离效能和检测效能。本文对此作介绍 ,以期对使用气相色谱仪进行地下水H2 、He观测的台站能有所启发和借鉴     

Science and the Consequences of Mistruct: Lessons from Recent GM Controversies

In 2001, it was announced thattransgenic DNA had introgressed intotraditional strains of maize in Mexico. Acontroversy erupted and raged throughout 2001and 2002. This episode represents an acutebreakdown in scientific discourse. Given thestakes in the genetically modified organismdebate, a breakdown in scientific discourse isalarming. The following inquiry looks into thecauses of this breakdown. Ultimately, it willbe argued that the underlying problem is thecurrent institutional structure of science,particularly in the United States. If thediagnosis is correct, then the proper course oftreatment is to pursue a program ofinstitutional reconstruction.     

Ring-Opening Polymerization of Cyclic Esters onto Liquefied Biomass

Ring-opening polymerization of cyclic esters (-caprolactone, -valerolactone, and l-lactide) onto liquefied biomass (LB) was conducted to obtain the polyester-type polyol and to regulate the characteristics of LB. IR and ¹H-NMR spectra of the obtained polyol showed that the polymerization was successfully conducted in the presence of acid catalyst, which is used in liquefaction. The molecular weight (M_w), hydroxyl value, and viscosity were controllable by changing the reaction conditions. Polyester-type polyurethane foams with a wide range of properties were prepared from the obtained polyol with the appropriate combinations of foaming agents.     

用改性活性碳纤维去除CO2原料气中的H2S

采用固定床动态吸附实验，用改性活性碳纤维（ACF）吸附去除CO2原料气中的H2S。通过改变改性剂种类、反应温度和原料气中CO2浓度，找出用改性ACF去除CO2原料气中H2S的规律。实验结果表明：常温下，可用NaON改性的ACF来消除CO2的酸性对去除H2S的不利影响；随着反应温度的升高，CO2与ACF形成的C（O＊）中间产物增多，CO2的存在有利于改性ACF去除H2S；而当反应温度过高时，CO2与ACF形成的C（O＊）中间产物发生分解，导致ACF碳化，不利于H2S的吸附去除。     

空心玻璃微珠对泡沫灭火剂发泡能力和热稳定性影响研究

本文研究了空心玻璃微珠添加量及泡沫液浓度对泡沫灭火剂发泡能力和稳定性的影响,对比了热辐射条件下空心玻璃微珠添加前后泡沫的热稳定性.结果表明,添加量低于40%时,空心玻璃微珠对泡沫灭火剂发泡能力影响不大,而泡沫的稳定性显著降低,添加量为50%时,虽泡沫发泡能力降低,但泡沫的稳定性却增强.泡沫的发泡能力随蛋白泡沫浓度升高而增强.蛋白浓度为10%,空心微珠添加量为50%时,由于泡沫内部形成了稳定的三相泡沫骨架结构,泡沫热稳定性较未添加微珠之前显著增强.     

改性木屑吸附剂对印染废水的脱色性能研究

本文介绍了以廉价易得的杨树木屑为原料，经环氧氯丙烷交联，制备的一种新的生物吸附剂，研究各种反应因素（氢氧化钠浓度、环氧氯丙烷用量、反应温度、木屑粒径等）对反应过程和吸附剂性能的影响，检验了其对品红及孔雀石绿在不同条件下的吸附性能，并探讨了它的吸附动力学曲线和再生性能。     

聚氨酯泡沫材料阴燃发展过程的特性分析

分析对比了相同加热条件下的聚氨酯泡沫材料在有氧和无氧气氛下的升温过程,并对不同加热条件下的聚氨酯泡沫材料的阴燃传播速度进行研究.结果表明:沿着反应进行的方向,分离点的温度越来越低,不同热流条件下的温度分离曲线斜率在实验稳定发展段的变化规律表现得很相似,并在分离点出现后,有氧气氛中的该位置温度在短时间内急剧上升;在阴燃不稳定传播阶段时,热解前锋的速度小于氧化前锋的速度,在稳定传播阶段时,热解前锋速度与氧化前锋速度近乎相等.     

改性酚醛基炭泡沫的表面结构及脱硫脱硝

采用前驱体改性的方法,以CuCl2、FeCl2和MgCl2为改性剂,制备出改性酚醛泡沫,经炭化/活化得到改性酚醛基炭泡沫。研究了不同金属对酚醛基炭泡沫表面物理与化学特性的影响,并进行同时脱硫脱硝实验研究。通过研究发现,添加CuCl2的样品比添加FeCl2、MgCl2的样品的中孔孔容大接近10倍;比表面积和孔容是CFCu>CF0>CFFe>CFMg;金属改性剂主要以金属和金属氧化物的形式存在于酚醛基炭泡沫中,而表面其他官能团大体结构不变。经CuCl2、FeCl2和MgCl2改性后,脱硫效率分别提高了39%、11%和13%,脱硝效率分别提高了19%、10%和4%,其中以CuCl2改性的酚醛基炭泡沫的效率最高。     

Disparity of a Seat Cushion and Its Influence on Postural Control

Properties of supporting surfaces of a seat have an influence on postural control. Centre of pressure (COP) displacement parameters reflect both the balance controlling process and movements of the centre of a mass of entire body. The subjects of the study were 9 healthy men. A seat cushion was examined with a 2-force platform setup. Force exertion at a seat pan and feet and COP displacement at a seat pan were measured to analyse postural control. Analysis of variance determined the differences in postural control depending on a cushion type among the subjects. Significant differences in COP displacement parameters were in COP trajectory length, medio-lateral COP displacement and COP velocity. The results of the study showed that foam cushion ensures better postural control.